Alpha-technologies FXM Communication Manuel d'utilisateur télécharger pdf (Page 11)

FXM Communication Manual

Procedure

If you are installing multiple UPS’s on the same network, before installation,

congure each unit’s IP address. Each UPS on the network MUST have its own

unique IP address (See Section 4.2, “Operation, Communications, Congure

TCP/IP”).

1. Connect the UPS to the computer with either the cross over cable or with a hub.

2. Turn on the computer.

3. Congure the network card to talk to the FXM Communication module (the module’s

default address is http://192.168.0.90).

4. Type the IP address into the browser and press ENTER.

The input and output screen appears (See Section 3, “UPS Monitoring, Input and Output”).

5. Go to the communications screen, “Congure TCP/IP” (See Section 4.2, “Operation,

Communications”) and congure the TCP/IP properties according to your network’s

requirements. Push the Apply Settings button. The screen will prompt you for the

password. The factory default password is 1111.

6. Connect UPS to the congured network per your new properties.

7. Access the UPS per the new network properties.

4.2 Operation

Many of the screens used for Ethernet communications look and act the same and contain

the same information as the Novus User Software screens shown in Section 3. There are

additional screens only available with Ethernet communications which are detailed below.

SITE INFORMATION

This screen lets you enter site location information

into the UPS’s memory.

4 Ethernet Communication (Continued)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Alpha-technologies FXM Communication Manuel d'utilisateur Page 11