Alpha Technologies IP Bell - 02C Instructions d'exploitation télécharger pdf (Page 16)

IPDP - installation and operating instructions

- Manual switching DAY/NIGHT is by code which is programmed in

“switching codes” parametr.

- - mode 2 numbers groups = first press of button – always dials

number saved in 1 column ( 1st group) . When you press the same

button again, when busy tone is detected or when preprogrammed

number of rings is over the IPDP dials number from 2 column ( 2nd

group). When you press the same button again the IPDP dial number

from 1

group .

- When visitor press the button after IPDP makes line OFF HOOK then

door phone hangs up fot time preset by parametr “Time of hanging up

before REDIAL”. Then picks up and dial new number.

By buttons of IPDP you can dial a code for door opening (code keylock).

When visitor at the door press buttons combination which agree to

preprogrammed code and time between button press is not longer than

preprogrammed time by parametr the IPDP will activate appropriate relay

(when is set in mode m=1 or m=5) for time “Closing time”.

2.3 Person Inside Building

The person inside building is considered as person who is responding

Door phone calls by phone.

2.3.1 Outgoing Call

Outgoing call is call coming from door phone (inicialize by button press

by visitor). After door phone number dialling is ringing phone inside the

building. When you picks up the call you can speak to visitor as same as by

code dialling you can: activate relay ( when is set in mode m=1 or m=5), switch

DAY/NIGHT mode and hang up. The IPDP sends 10sec before end of call

duration notification ( 3 short beeps) and you have an option to prolong the call

by dialling (* / #) . By hanging up of phone is call ended..

There are 2 ways how to transmit info about button press (code for door

opening, DAY/NIGHT switching code, call prolongation code, code for

hanging up etc..) –either in “RTPchannel” or in “SIP info” . Version

“inband DTMF” is not decoding in IPDP .

2.3.2 Incoming Call

Incoming call is call coming from the building to door phone. (Inicialize

by person inside building). After dialling of extension number or IP adress (

where is IPDP connected) the door phone is ringing (LED is flashing).

After preprogrammed number of rings the IPDP picks up and you can talk.

Available services are the same as at outgoing call (chapter Fel! Hittar inte

referenskälla.).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 42 43

Pas de commentaire

Alpha Technologies IP Bell - 02C Instructions d'exploitation Page 16