Alpha Technologies IPDP - 00C Manuel d'utilisateur télécharger pdf (Page 22)

Parameter

Value

Description

Default

Deletes all numbers in group 1

(Day mode)

Deletes all numbers in group 2

(Night mode)

Default setting only for parameters 3x

only 3..

Default setting only for parameters 4x

only 4..

Default setting only for parameters 5x

only 5..

The parameters 81 and 82 will delete all numbers stored in memories for

buttons.

The parameters 83  85 will execute a selective basic setting only for

parameters starting with 3..  5..

ATTENTION !!! the deletion is non-reversible!!! Numbers must be programmed

again.

5.6 Exit programming

Parameter

Value

Description

Default

E N D

After dialling 9 the unit will hang up.

5.7 System setting

Parameter

Value

Description

Default

Number of fitted buttons of basic module

The basic module is fitted with 4 buttons as standard, i.e. s = 1 is set up for

basic module with one button and s = 2 for module with 2 buttons. This setting

is a factory one, no service can change it and so it is recommended not to

change this parameter.

Note: Connecting to the line the value of this parameter is checked and if not

satisfactory for unknown reasons, so it is set up to s = 4 (fitted with 4 buttons).

ATTENTION !!! This parameter can cause the unit to function incorrectly.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

Pas de commentaire

Alpha Technologies IPDP - 00C Manuel d'utilisateur Page 22