Alpha-technologies Serial System Controller Manuel d'utilisateur télécharger pdf (Page 23)

2. Installation

23 018-332-C0-002 Rev. B

Figure 2-1; Location of Communications Module in XM2 Power Supply

Note: If the XM2 system already has a Serial System Controller (SSC)

module installed, proceed to section 2.3, Smart Display Setup

Menu.

Note: During this procedure, backup capability may be temporarily lost.

Module Conversion Procedure:

1. Disconnect any status monitoring cables/harnesses connected

to the front panel of the existing module. (Module shown for

illustrative purposes only.)

2. Verify that the battery breakers are OFF.

3. Disconnect the battery cable connections.

4. Unscrew the captive mounting/grounding screws located on the

lower front panel (and top right, if applicable) of the Inverter

Module (IM).

2.1 Module Conversion

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Alpha-technologies Serial System Controller Manuel d'utilisateur Page 23